Good thing you can disable this feature and it'll only take a short time to do so. Here's what you need to do. Put the key inside the ignition and turn your vehicle on. Push the unlock button three times. Turn off the ignition and repeat Step 2. Turn on the ignition and wait for the horn to beep. Spread the love. A door locking motor is fitted to each door and connected to a control box located under the fascia in front of the steering wheel. A 20 amp fuse is incorporated to protect the System, see figure 1. A key operated microswitch is incorporated in the driver’s door locking motor. Table of Contents show. 1 post · Joined 2017. #1 · Nov 20, 2017. Hi, I have a problem with the central locking on my 2012 Tucson LHD. When I activate the locking or unlocking, the drivers door locks/unlocks fine, but the passenger and rear doors do not. The lock on the doors seems to move a little but they wont lock or unlock. Sometimes the locks will activate if The other doors behaved the same with respect to the lock button when using the key fob to open or close. But, using the key in the door and unlocking worked every time and moved the inside button fully. Double key unlock would unlock all the inside doors every time. Key in the door also locked all the doors every time. I purchased a new 2017 HRV EX in September of this year. Yesterday I noticed that as I was driving, the doors started to automatically lock-slightly unlock-lock-slightly unlock-lock-slightly unlock-etc, lasting for maybe a minute or two. It happened a few times last night and then a few more times today, all as I was driving 10-30mph. Hi, there are a few topics about the central locking on here but struggling to get my issue resolved. (Audi a3 2006 8p) a year or two ago the remote fob became intermittent and had less range. Changed the batteries and it didn’t make a difference. Eventually the remote stopped working (on Both keys) so had to physically use the key to gain TECHNICAL SERVICE BULLETIN No.67/1999 Car and Light/Medium Commercial 08.07.1999 Section: 41 Model: Ka with central locking, (buildcode XL) Markets: All Subject: Central locking failure or incorrect operation Summary Should a customer express concern over failure or incorrect operation of the central locking, this could be caused by corroded or damaged pins in the door wiring harness connector. 1. Open central locking system using the car key. 2. Get into the car and close all doors. 3. Using the car key, switch the ignition lock briefly to position "1" and then switch off again. (Please do this switching within 5 seconds or otherwise the system is not ready for initialization. 4. 1 post · Joined 2023. #1 · Sep 1, 2023. I have a 2009 (B7) A4 Quattro Cabriolet S-line and the key fob stopped working, as did the lock/unlock buttons on the doors. Otherwise the car runs great. The key in the drivers door only opens the driver's door. If I get in and then open the passenger's door from the inside handles, a very loud beeping mx4g2dW.